How to solve the delay failure of Waste Processing Equipment?

Waste Processing Equipment is mainly used for sorting stale domestic garbage buried in urban landfills for many years, and can also be used for sorting garbage in new live garbage concentration areas. This equipment can separate domestic waste into four parts, such as fuel, organic soil, recycled materials and stones. In the case of no deep treatment device, the use of combustible incineration, organic soil below 20m/m for landscaping, renewable materials recycling (such as waste plastics used as secondary plastics), stones used as building materials and other simple methods of treatment. The waste can be reduced, recycled and harmless, and the land of the treated garbage pit can be used for city construction or the goal of repeatedly burying garbage in one pit.

1, reduce the system software, no gear oil or car oil tank level is low: to the car oil tank to fill the oil, and check the system software leakage; Gear oil viscosity does not comply with the application regulations: this manual strongly recommends the use of cooking oil; Fine oil filter/coarse oil filter dirty or blocked: replace new, and find environmental pollution reasons; The oil flow is blocked, restricted, and impeded: it will be caused by the hydraulic pipeline is dirty or the inner cavity is damaged, clean the pipeline or disassemble the oil pipeline; Gasoline pump more serious damage: repair or disassemble, and search for reasons, such as installation errors or dirty oil.

2, the components are more serious damage: regular inspection and detection of pumps, valves, hydraulic cylinders and other internal and external leaks, if there is dirty damage, find out the reason; Gear oil leakage of working pressure pipeline: tighten the tee joint and replace the damaged water pipe or connector. Check whether the surface of the phase parts fusion is convex and concave; Component adjustment error: refer to the relative technical guide to master the proper adjustment of components; The pressure valve has common faults or is very dirty: check whether the pressure valve can be opened at the rated working pressure, whether there are damaged hydraulic seals, and clean the pressure valve. Check to see if the bullet has come loose.

3, the gasoline pump rotation orientation is wrong: replace the appropriate gasoline pump; System software work overweight: find out the car load standard, according to the prescribed limit load application system software; Pipeline connection is not good: change the installation situation, fixed plastic hose; Gasoline pump not working damage: repair or disassembly; There is gas in the system software: check whether there is leakage in the suction pipeline of the system software, and whether the aspect ratio of the oil tank liquid level is positive; Gear oil temperature is low, gear oil viscosity is too high at the beginning of work: should be in the system software before the work, so that the Waste Processing Equipment oil temperature exceeds the operating temperature; Motor rated power is insufficient: repair or disassemble.